Which of these types of engineered lumber would be more likely to be used for millwork than as support beams?
a. Glulam
b. LVL
c. PSL
d. LSL
Answer: D
You might also like to view...
The service consultant is asked by a customer to install a used part that is not designed for the vehicle being repaired. The best response from the service consultant is_________
A. Approve the request and do the repair B. Reject the request because it will put the company at risk if it fails C. Reject the request because it will not help the customer D. Reject the request because it will not promote part sales
A driver complains that when his truck engine is under load, whenever he removes his foot from the accelerator pedal, engine rpm drops below specified idle speed and occasionally stalls. Which of the following terms is used to describe this condition?
A. wide open throttle B. underrun C. overrun D. droop
When an inlet metering, opposed plunger rotary distributor pump is adapted for management by computer, which of the following terms best describes the system?
A. full authority B. partial authority C. state of the art D. high tech
Technician A says that water floats to the top of fuel in the tank. Technician B says that water is more likely to be drawn into the system when the fuel level is low. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B