Cuttings' leaves lose moisture through _____

A) photosynthesis
B) respiration
C) transpiration
D) guttation


C

Trades & Technology

You might also like to view...

When detailing structural steel beams, the steel detailer oft en shows running dimensions. These dimensions are always taken from what end of the beam?

What will be an ideal response?

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. Small alternate sources of electric power are often used to reduce the demand on the power grid that is normally supplied from utility power stations. 2. All regions in the United States have significant wind power available on a consistent basis, which makes them good candidates for wind-powered generation. 3. With direct drive and variable speed, the wind turns the turbine, which spins the generator, or a speed converter gearbox is used to produce sync speed. 4. Small wind turbine systems are covered in NEC Article 496. 5. Separately derived systems constitute alternative energy.

Trades & Technology

Flat taper may be specified as:

A. flat taper per inch, flat taper as a ratio, or conical taper B. flat taper per inch, flat taper as a ratio, or flat taper in degrees C. flat taper per inch, Morse taper, or flat taper as a ratio D. ?

Trades & Technology

CNG as a vehicle fuel is cheaper than gasoline and has a higher heat value than gasoline

Indicate whether the statement is true or false

Trades & Technology