Industrial plasma cutting units can cut carbon steel up to _____
a. 1" thick
b. 3" thick
c. 5" thick
d. 7" thick
b
You might also like to view...
The subsequent problems deal with a measurement system with a frequency response as shown below: For all input frequencies between 3.5 and 4 rad/sec, the system output amplitude will be
A. amplified B. 0 C. attenuated, but nonzero D. negative E. 1
In an alkaline soil, much of the iron in most iron chelates is rapidly replaced in the chelate complex by which other metallic nutrient?
A) Cu B) Ca C) K D) Zn E) Mn
Head gasket installation is being discussed. Technician A says that the surface finish of the cylinder head or block deck is very important for proper sealing to occur. Technician B says that if "front" is marked on a head gasket, the mark should be installed near the accessory belt end of the engine. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
To prevent liquid slugs from leaving the evaporator and entering the compressor, direct expansion evaporators:
A) Are typically fed at the bottom with suction gas leaving at the top. B) Are typically fed at the top and bottom with suction gas leaving in the middle. C) Are typically fed at the top with suction gas leaving at the bottom. D) Are typically fed in the middle with suction gas leaving at the top and bottom.