Why are drawings not necessary for standard parts?
What will be an ideal response?
Standard parts do not have to be drawn because a written description clearly identifies the part.
You might also like to view...
________ rooting occurs in the tissue culture vessel like a test tube, while ________ rooting occurs outside the tissue culture vessel - like a greenhouse flat.
Fill in the blank(s) with the appropriate word(s).
Technician A says that an engine will likely miss under load if the ignition coil is tracked. Technician B says that one wire of a waste spark coil must be grounded. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
After a TP sensor has been tested using the MIN/MAX function on a DMM, a reading of zero volts is displayed. Which of these does this reading indicate?
A) The TP sensor is shorted B) The TP sensor signal is shorted to 5-volt reference C) The TP sensor is open at one point during the test D) Both B and C are possible
Adhesives are usually used for repairing minor cuts and cracks in plastic parts.
Answer the following statement true (T) or false (F)