Si se está construyendo un edificio en el que se aplicará revestimiento sobre el entablado, se debe usar un entablado de un espesor mínimo de _____.
a. 3
?8" (0.9 cm)
b. 1
?2" (1.3 cm)
c. 5
?8" (1.6 cm)
d. 1" (2.54 cm)
Answer: A
You might also like to view...
When timing the overhead camshafts used on a pre-2010 Cummins ISX engine geartrain, which of the following tools must be used?
A. dial indicator B. timing wedges C. Plastigagetm D. calibration indices
Which statement is correct?
A) Dirt is most likely to be found near the bottom of the fuel tank. B) Throttle body injectors inject fuel below the throttle plate. C) Dirt is most likely to float on top of the fuel. D) Port fuel injectors inject fuel above the throttle plate.
How should the vacuum gauge and vacuum pump be connected to a four-port manifold?
A) The vacuum gauge is connected to the 1/4-in center port, and the vacuum pump is connected to the 3/8-in center pump. B) The vacuum gauge is connected to the discharge service valve, and the vacuum pump is connected to the evaporator coil. C) The vacuum gauge is connected to the 3/8-in center port, and the vacuum pump is connected to the 1/4-in center pump. D) The vacuum gauge is connected to the evaporator coil, and the vacuum pump is connected to the discharge service valve.
What stabilizes the up-and-down motion of the vehicle when travelling on a bumpy road?
What will be an ideal response?