ASME standards require a radius dimension to be preceded by the symbol ____.
A. DIA R
B. DIA
C. R
D. DR
Answer: C
You might also like to view...
What are crustaceans?
What will be an ideal response?
After assembling a drum brake, it is discovered that the brake drum will not fit over the new brake shoes. Technician A says that the parking brake cable may not have been fully released. Technician B says to check to see if both shoes are contacting the anchor pin. Which technician is correct?
A) Technician A only B) Technician B only C) Both Technicians A and B D) Neither Technician A nor B
What two important things should be done before pressing in a bushing?
A) Clean all the oil off the bushing and wash your hands so you won't get contaminated B) Oil the bushing and start it in the bore with a hammer before you start pressing C) Chamfer and lubricate the bore D) None of the above
When a load is placed on a truck with a C-channel, ladder frame, which ONE of the following is true of the C-channel rails?
A. neutral fiber is under compressional force B. upper flange is under tensional force C. lower flange is under tensional force D. the entire rail is under compressional force