Deburring tools are used for:
A) Preparing a compressor head before applying a head gasket.
B) Removing the small burr left by pipe cutters.
C) Removing splinters from wood frame members.
D) Removing rough edges from electrical wiring.
B
You might also like to view...
Use a sketch and notes to illustrate two methods of attachment when gypsum board is used as a finish ceiling material.
What will be an ideal response?
What points should you bear in mind when using a scan tool to diagnose driveability problems while watching fuel trim?
What will be an ideal response?
Technician A says that all the fuel injectors on an engine should have the same electrical resistance
Technician B says that the difference between any two injectors should be less than 2 ohms. Which technician is correct? A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Why is chordal action a problem in a chain drive?
What will be an ideal response?