Because blocks are heavy, hollow, and somewhat awkward to handle, care must be taken to prevent them from spalling, which is also known as ______ .
A. sinking
B. falling
C. breaking
D. chipping
Answer: D
You might also like to view...
Andrews Electronics made a decision to compete in the market for video camcorders and
videocassette recorders. Which component of the company's strategy did this decision reflect?
a. Scope b. Resource deployment c. Distinctive competence d. Synergy e. Entropy
Which of the following statements is correct about sizing the supply-side bonding jumper on the line or supply side of the service equipment?
A. It is sized from Table 250.66 in accordance with the size or rating of the overcurrent protective device in the service equipment. B. It is sized from Table 250.122 in accordance with the size rating of the overcurrent protective device in the service equipment. C. It is sized from Table 250.102(C)(1) in accordance with the size of the service-entrance conductors on the supply side of the service. D. It is sized from Table 250.122 in accordance with the size of the service-entrance conductors on the supply side of the service.
What device is used to perform current-to-voltage conversion?
A) voltage regulator B) operational amplifier C) demultiplexer D) multiplexer
Most problems with friction clutches are caused by:
A. Excessive heat. B. Too much torque. C. oil or contaminants on the friction surface. D. none of the above.