Attachment plugs and receptacles in hazardous locations must be listed for use in _____.

a. Class I, Group A locations
b. Class I, Group B locations
c. Class I, Group C locations
d. Class I, Group D locations


c. Class I, Group C locations

Trades & Technology

You might also like to view...

Which statement regarding the relationship between managerial skills and managers’

activities is NOT correct?

a. Technical skills are probably most important at the level of the first-line supervisor. b. Good interpersonal skills are absolutely essential to the manager’s success. c. Diagnostic and analytic skills are extremely important to the decision-making process. d. Conceptual skills are most important to top managers. e. The mix of skills required of a manager depends on the level of management at which he or she works.

Trades & Technology

Analyze the reinforced concrete frame in Figure P14.7. Determine all reactions. E is constant.

Trades & Technology

When drawing a PH diagram of an operating system, how is placement of the metering device line determined?

A) The metering device line starts where the condenser line crosses the temperature of the liquid line and then drops straight down until it crosses the evaporator line. B) The metering device line starts where the condenser line crosses the temperature of the liquid line and then goes straight across until it crosses the compressor line. C) The metering device line starts where the condenser line crosses the temperature of the liquid line and then drops straight down until it crosses the compressor line. D) The metering device line starts where the compressor line crosses the temperature of the liquid line and then drops straight down until it crosses the condenser line.

Trades & Technology

Describe an aligned section, and include information about how the sectional view is shown in relation to the cutting plane line.

What will be an ideal response?

Trades & Technology