Match the description of each step used in the calibration process shown with the proper sequence of steps listed.
A. Step 1
B. Step 2
C. Step 3
D. Step 4
E. Step 5
A. Determine the full range of the variable being measured.
B. Select an appropriate sensor for the application and then determine the type of analog output signal produced by the transmitter.
C. Make a zero adjustment which causes the minimum analog output of the transmitter to be generated when the minimum value of the variable is measured.
D. Make a span adjustment which causes the maximum output of the transmitter to be generated when the maximum value of the variable is measured.
E. Verify that the zero and span adjustments are accurate when the minimum and maximum values of the variable are measured.
You might also like to view...
The growing period for pigs is from weaning to about _____ pounds
a. 100 c. 150 b. 125 d. 175
Healthy amphibian skin is _____
a. shed regularly b. tacky and dark c. not shed d. shed in patches
Use the following engine dimensions to calculate the compression ratio
Bore: 3.920 in. Stroke: 3.300 in. Gasket thickness: 0.050 in. Deck height: 0.010 in. Piston dish volume: 7.8 cc Combustion chamber volume: 59.0 cc A) 9.3:1 B) 9.4:1 C) 9.1:1 D) 9.2:1
Water treatment is necessary to protect the system components against
A) scale, corrosion, and fouling B) fouling, freezing, and evaporating C) freezing, evaporation, and sublimation D) hypothermia, outgassing, and corrosion