Describe the identifying characteristics of sugar gliders
What will be an ideal response?
One of the most distinguishing characteristics of the sugar glider is the patagium, or thin, furred membrane
that stretches from the wrists to the ankles. When not gliding, the membrane appears as excess skin on the
side of the animal.
The female sugar glider has a pouch. This pouch can be seen as a small slit at the lower abdominal area.
Sugar gliders have a body length of 5 to 6 inches with a tail of near equal length, giving the animal a total
length of approximately 10 to 12 inches. They weigh three to five ounces, with the males being slightly larger
than the females.
The head is somewhat triangular. The muzzle is short, and the nose is rounded. Their eyes are large and
round. Sugar gliders have 40 to 46 teeth, including the two incisors that are large and protrude forward.
Sugar gliders normally have soft, gray-colored fur with cream-colored undersides. They have a black stripe
that runs from between the eyes, over the head, down the center of the back, to the base of the tail.
Sugar gliders have black rings around the eyes and black stripes on the front of each leg. They have a bushy
tail, which is also gray in color except for the last couple of inches, which is black. Their ears are furless and
fairly large. The ears move independently of each other and are constantly in motion, trying to pick up sounds.
Adult males have a scent gland that appears as a bald spot on the head, and this bald spot separates the
black stripe as it crosses over the head.
You might also like to view...
When constructing a wall frame, the proper nailing surface for gypsum board is _____.
a. 1/8" to 1/4" b. 1/4" to 1/2" c. 3/8" to 1/2" d. 3/4" to 1"
All of the following statements are true EXCEPT:
A. when replacing a bearing, use a press and support the outside of the bearing with a bearing separator. B. the drive gear for the VSS or speedometer is located on the output shaft. C. synchro sleeves wear either on the outside edge of the tooth or on the inside, partway into the sleeve. D. when synchros have experienced wear, the teeth on the corresponding gear could also be worn.
Which of the following governing classifications would allow the accelerator pedal in a truck diesel engine to respond like that in an automobile?
A. limiting speed B. variable speed C. isochronous D. all-speed governor
In commercial construction, many federally funded large-scale projects use the U. S. customary system of measurements
Indicate whether the statement is true or false