Carbon steel pipe welds made with GTAW normally require a 15- to 20-degree _____

a. push angle
b. drag angle
c. work angle
d. bevel angle


a

Trades & Technology

You might also like to view...

?The company Moldflow® is prominent in the field of ____.    

A. ?rapid prototyping B. ?computer-aided flow analysis C. ?computer-aided design  D. ?computer-aided engineering

Trades & Technology

Daily inspection of an excavation must be performed by a(n) _____

a. qualified person b. competent person c. foreman d. engineer

Trades & Technology

Two technicians are discussing deceleration rates. Technician A says that a one "g" stop is a gentle slowing of the vehicle. Technician B says that a stopping rate of 8 ft/sec2 is a severe stop. Who is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

The maximum allowable alternating current (AC) that is being sent to the battery from the alternator is ________

A) 3 to 4 A B) 10% of the rated output of the AC Generator C) 0.04 A D) 1 to 3 A

Trades & Technology