Relay problems fall into the same two groups as switch problems, namely operators and contacts

Indicate whether the statement is true or false


FALSE

Trades & Technology

You might also like to view...

Answer the following statement(s) true (T) or false (F)

1. A perpendicularity tolerance can only constrain rotational degrees of freedom relative to the datum referenced. 2. Perpendicularity can be applied to a planar surface, but not to a feature of size. 3. Where two datum references are used with a perpendicularity tolerance, the tolerance zone is perpendicular to the primary datum reference. 4. When a perpendicularity tolerance is applied to a planar surface, the deviation is verified by finding the distance between two parallel planes that all of the points of the surface are located within. 5. A common method used to verify a perpendicularity tolerance (MMC) is to use a height gage.

Trades & Technology

A squeal is heard as the clutch pedal is depressed about one inch. This is probably caused by a ________.

A) Weak pressure plate B) Worn clutch disc C) Worn pilot bearing D) Defective or worn release (throwout) bearing

Trades & Technology

Technician A says that LNG is stored in liquid form on vehicles using the fuel. Technician B says that CNG is stored in gaseous form in vehicles using the fuel. Who is correct?

A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B

Trades & Technology

Two technicians are discussing the front axle disconnect mechanism. Technician A says that the front axles are only disconnected if the vehicle is being towed. Technician B says that this unit is only used on all-wheel-drive vehicles. Which technician is correct?

A) Technician A B) Technician B C) Both technicians D) Neither technician

Trades & Technology