A press fit and an interference fit are the same thing

Indicate whether the statement is true or false


TRUE

Trades & Technology

You might also like to view...

The load calculation form results (overcurrent protection and conductors) represent ____ requirement.

A. the complete B. only a minimum C. the first part of the D. the written portion of the

Trades & Technology

What procedure is used when heating a brazed copper joint?

A) Heat the fitting first and then heat the pipe after the fitting is hot. B) Heat the pipe first and then the fitting. C) Use a fanning motion to heat the fitting evenly and slowly. D) Concentrate the flame on the line where the pipe slips into the fitting.

Trades & Technology

A vehicle is in for service with a complaint of poor heat output. The technician finds air trapped in the heater core. What is the most likely cause of this condition?

A. A faulty radiator fan switch. B. A leaking cyclinder head gasket. C. Worn water pump impeller blade. D. A stuck open engine thermostat.

Trades & Technology

Primary auxiliary views are views that take the place of a principal view.

Answer the following statement true (T) or false (F)

Trades & Technology