When priming a primary fuel filter during a service, which of the following is best practice?
A. pressurize the fuel tanks with shop air
B. crank the engine for 30 seconds
C. pour fuel only into filter inlet
D. pour fuel only into filter outlet
Answer: C
You might also like to view...
____________________ charts are often used to estimate shading at an installation site.
Fill in the blank(s) with the appropriate word(s).
All of the following statements are true EXCEPT:
A. shifts can be either too late, with the engine rpm too high, or too early, with the engine lugging. B. a transmission that shifts at the wrong time could be the result of a pressure problem or a sticking valve in the valve body. C. pressure problems can be caused by a leaking modulator, a misadjusted throttle valve cable, or a sticking governor. D. clutch chatter can be caused by a leaking modulator, a misadjusted throttle valve cable, or a sticking governor.
Refer to the shaft shown in the accompanying figure. If B, C and D are 1/2, 5/8 and 1 7/32 inches respectively, what is the length of A?
What will be an ideal response?
The efficiency of the heat engine sketched in the figure is nearest
A) 11%
B) 18%
C) 22%
D) 33%