Framing bits that synchronize the equipment are also called synchronization flags, or:

A) Fm bits B) Fr bits C) Ft bits D) Fs bits


C

Trades & Technology

You might also like to view...

The front view is usually most important because it is the one from which the other views are established.

Answer the following statement true (T) or false (F)

Trades & Technology

D = Diameter of circleCarry the answer to two decimal places. A circle has a circumference of 10'. Find the diameter.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

The gas tungsten arc welding process is sometimes referred to as TIG welding.

Answer the following statement true (T) or false (F)

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. The modulus of rigidity is a measure of how easily a material will stretch when pulled or how well the material will shorten when pushed. 2. Concrete is stronger in tension than it is in compression. 3. The coefficient of linear expansion can be used to determine the change in the length (per original length) of a material that would occur if the temperature of the material were changed. 4. The value of heat capacity represents the amount of thermal energy required to raise the temperature of 1 kilogram mass of a material by 1°C. Materials with large heat capacity values are good at storing thermal energy. 5. The lower the viscosity value is, the more resistance the fluid offers to flow.

Trades & Technology