When heat-activated tape is used for duct closure, before applying any sort of stress, all joints and seams
should be allowed to cool to a temperature below _____.
a. 100°F
b. 125°F
c. 150°F
d. 175°F
c
You might also like to view...
The ____ are a tool used by an electronics technician to straighten component leads.
A. needle nose pliers B. flat nose pliers (duck bill) C. round nose pliers D. diagonal cutters (flush)
?All of the following are examples of recommendations for HV battery removal and replacement EXCEPT:
A. ?shut down the HV electrical system. B. ?refer to factory service information C. ?remove protective covers D. ?use an engine crane or extension jack
In the accompanying figure, Radius A = 370 mm and x = 470 mm. What is y in mm to one decimal place?
What will be an ideal response?
Explain the terms arrow side and other side and indicate where the weld symbol is located on the reference line when using arrow side and other side.
What will be an ideal response?