When cutting thin steel with oxyfuel cutting equipment, point the torch tip in the direction the torch is

traveling at a _____.

a. 10- to 12-degree angle
b. 15- to 20-degree angle
c. 21- to 25-degree angle
d. 30- to 35-degree ang


b

Trades & Technology

You might also like to view...

Using a ____ arc current setting with ____ travel speeds is important when welding stainless steel.

A. high, slower B. high, faster C. low, slower D. low, faster

Trades & Technology

Which of the following is NOT a reason that most dimensions and tolerances are shown in decimal form:

A. Decimals are easier to work with B. Decimals provide tighter tolerances than fractions could C. Machine tools are graduated in decimal form D. Measuring tools are in decimal form

Trades & Technology

About 60 percent of the _____ in the United States are raised for meat in Indiana by one company.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

A light film of oil is observed on the upper area of a shock absorber. Technician A says that this condition should be considered normal. Technician B says that a rod seal may bleed fluid during cold weather, causing the oil film. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology