When are the two universal joints on a driveshaft operating in-phase?
A. transmission and rear axle are on the same horizontal plane
B. the two shaft sections are on the same vertical plane
C. the slip-yoke lugs and the tube-yoke lugs are aligned with each other
D. all of the above
Answer: C
You might also like to view...
Which of the following pieces of information would you find in a technical spec?
a. spot elevations b. warranty period for plants c. dimensions for details d. location of utility lines
Which of the following is true of backhand welding?
A. It has good joint visibility and makes welds with less joint penetration. B. It works well on vertical up and overhead welds. C. It has good bead visibility and makes welds with deeper joint penetration. D. It has a good balance between penetration and reinforcement and is used on automated welding.
Many prints specify sizes for fillets and rounds in a note, rather than dimensioning each one.
Answer the following statement true (T) or false (F)
Technician A says that active fuel management is only used on large V8s. Technician B says that active fuel management increases fuel economy. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician