____ is an operation that is used on sheet metals. As with deep drawing, a metal is deformed between a cavity and a closely fitting plunger. The edge of the plunger fits closely to the edge of the cavity, and the metal is cut with a shearing action.
A. Stamping
B. Sintering
C. Forging
D. Sloped drawing
Answer: A
You might also like to view...
A right triangle is any triangle with _____.
a. two equal sides b. three equal sides c. one 90° angle d. one 45° angle
While working on a PM crew, it is easy to hurry and cut corners due to time constraints.
Answer the following statement true (T) or false (F)
Answer the following statement(s) true (T) or false (F)
1. Commissioning is the initial start-up and operation of a PV system 2. The electrical inspector will make sure that the building codes adopted by the local government are being followed. 3. Conductor insulation on PV systems should be rated for wet locations. 4. The last item to check when performing the final check is signage. 5. Stand-alone PV systems will require less maintenance than grid-tie systems.
A lamp that produces light as a result of current passing through a resistive filament is using ____.
A. high-intensity discharge lighting B. resistive lighting C. incandescent lighting D. fluorescent lighting