If an actual part is large, the dimensions for a drawing are reduced by multiplying the actual dimension of the part by a scale factor greater than 1.

Answer the following statement true (T) or false (F)


False

Trades & Technology

You might also like to view...

The NPS pay scale correlates to the General Service pay scale

Indicate whether the statement is true or false

Trades & Technology

Which of the following is true about qualifying the WPS?

A. It must be qualified to verify that the list of variables will provide a sound weld. B. It is not necessary to keep a record of all parameters used to produce test welds. C. The PQR is for the benefit of the welder; the inspection agency will not request it. D. Sample welds are prepared using an established code or specification.

Trades & Technology

Why is it a good idea to partition your hard disk?

What will be an ideal response?

Trades & Technology

Can you use a normal voltage level for VLSI devices in handling high-priority traffic and a lower voltage level for low-priority traffic? Explain clearly.

What will be an ideal response?

Trades & Technology