Explain how you would identify the location of the shift forks when reassembling the engine.
What will be an ideal response?
Shift forks are usually marked with a letter identifying them as left, right or center. Sometimes the center fork is not marked.
You might also like to view...
Places of assembly are buildings, or portions of buildings, designed (or intended) for the assembly of ____ or more persons.
A. 50 B. 100 C. 500 D. 1000
What is the estimated length of a wall that is covered by 12 pieces of sheathing hung vertically?
A) 48 feet B) 72 feet C) 24 feet D) 98 feet
With the system operating, a technician gets a reading of 20 volts between the L1 and T1 terminals at the contacts of the contactor. This tells the technician that:
A) The contacts are defective because they have a measurable voltage drop. B) The compressor is defective. C) The contactor is operating correctly. D) The transformer is defective because the voltage should be 24 volts.
Which of the statements below best describes the basic operation of a dual-slope A/D converter?
A) A ramp voltage and analog input voltage are applied to a comparator. As the input voltage causes the integrating capacitor to charge, it will at some point equal the ramp voltage. The ramp voltage is measured and displayed on the digital panel meter. B) A ramp generator is used to enable a counter through a comparator. When the ramp voltage equals the input voltage the counter is latched and then reset. The counter reading is proportional to the input voltage since the ramp is changing at a constant V/second rate. C) Two ramps are generated: one by the input voltage and the other by a reference voltage. The input voltage ramp charges the integrating capacitor, while the reference voltage discharges the capacitor and enables the counter until the capacitor is discharged, at which time the counter value is loaded into the output latches. D) The input voltage is used to set the frequency of a voltage-controlled oscillator (VCO). The VCO quits changing frequency when the input voltage stabilizes. The frequency of the VCO, which is proportional to the analog input voltage, is measured and is displayed on the digital display as a voltage reading.