A transmission gear ratio is 3.7:1. The crankshaft speed is 2,479 rpm. What is the rpm of the driveshaft?
A. 630
B. 635
C. 660
D. 670
Answer: D
You might also like to view...
All of the following are true about as-built drawings except _____.
a. they are submitted to the architect/engineer as part of the closeout documents. b. the general contractor is responsible for recording changes. c. they are provided to the local building inspector to certify all local codes are met. d. they are developed to demonstrate project changes as they occur on site.
List three options for managing calves after weaning
What will be an ideal response?
The preferred method for connecting a circuit conductor to a device is to form a __________ in the wire, put it under a terminal screw, and tighten the screw properly.
a. terminal loop b. curve c. circle d. jug handle
A battery high rate discharge (load capacity) test is being performed on a 12 volt battery. Technician A says that a good battery should have a voltage reading of higher than 9.6 volts while under load at the end of the 15-second test. Technician B says that the battery should be discharged (loaded) to twice its CCA rating. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician