The REVSURF command will proceed if the curve to be revolved forms a closed contour
Indicate whether the statement is true or false
True
You might also like to view...
The piston-cylinder arrangement in Problem 16.12 was designed and rated with an internal pressure of 6.45 MPa. Prior to shipping, the cylinder is tested by increasing the internal pressure to 3.0 times the design pressure (safety factor of 3.0). What maximum force in newtons must be applied to the piston to hold it stationary during the test?
What will be an ideal response?
The only difference between an isometric drawing and an isometric projection is the ____.
A. terminology B. representation C. size D. both a and b E. none of the above
A hot compressor with an infinite ohms reading between common and the other two terminals and a reading of 4.3 ? between the start and run terminals most likely has:
A) An open start winding. B) An open internal overload. C) An open common winding. D) A shorted run winding.
A main source of heat used to warm the passenger compartment is _____________
A) Humidity. B) Sunlight. C) Ambient air. D) The vehicle engine.