Which state leads in catfish production?
a. Mississippi c. Wisconsin
b. Kentucky d. Connecticut
A
You might also like to view...
If the position of a bridge bent is +32 feet (10 meters) from Station 2, how far is the bent from Station 1?
a. 32 feet (10 meters) b. 64 feet (20 meters) c. 68 feet (21 meters) d. 132 feet (40 meters)
Computer analysis of a truss. The purpose of this study is to show that the magnitude of the joint displacements as well as the magnitude of the forces in members may control the proportions of structural members. For example, building codes typically specify maximum permitted displacements to ensure that excessive cracking of attached construction, such as exterior walls and windows, does not occur (Photo 1.1 in Section 1.3). A preliminary design of the truss in Figure P4.53 produces the following bar areas: members 1 through 4, 5 in. 2 , and members 5 and 6, 2 in. 2 . Also E = 29,000 kips/in. 2 . Case 1: Determine all bar forces, joint reactions, and joint displacements, assuming pin joints. Use the computer program to plot the deflected shape. Case 2: If the maximum horizontal
displacement of joint 4 is not to exceed 0.25 in., determine the minimum required area of the diagonal truss bars, members 5 and 6. For this case assume that the diagaonal members have the same areas, while all other truss members have cross-sectional area of 5 in. 2 . Round the area to the nearest whole number. Photo 1.1: Wind damage. Shortly after thermopane windows were installed in this high-rise office building, they began failing and falling out, scattering broken glass on passers-by beneath. Before the building could be occupied, the structural frame had to be stiffened and all the original glass panels had to be replaced by thicker, tempered glass—costly procedures that delayed the opening of the building for several years.
Technician A says that silicone grease can be used to lubricate the shoe contact ledges. Technician B says that synthetic brake grease, lithium brake grease, or anti-seize compound can be used as a brake lubricant. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
When preparing a resume, you should _____
a. use a font that is very creative and expressive b. format the information chronologically c. avoid any use of bulleted lists d. not mention any certifications until an interview begins