Which of the following is not typical for applying a RTV gasket maker?
A. Cleaning mating surfaces with mineral spirits
B. Apply a continuous bead 3mm in size
C. Wipe away excess sealant
D. Takes 24 hours to fully cure
Answer: A
You might also like to view...
A wrench that has an open end, and a box end, both of the same size, is known as a:
A. adjustable wrench B. spanner wrench C. open-box end wrench D. combination wrench
Answer the following statement(s) true (T) or false (F)
1. A straightness tolerance is a geometric tolerance that defines the straightness deviation permitted on individual surface elements or on a derived median line. 2. Wherever Rule #1 applies to a cylindrical feature of size, it invokes an indirect straightness deviation requirement on the surface elements. 3. Although Rule #1 provides an indirect straightness tolerance, a straightness tolerance should be specified on surface elements, unless it is a refinement of the dimensional limits of the size dimension (i.e., size tolerance). 4. Wherever Rule #1 applies to a cylindrical regular feature of size, an indirect straightness deviation requirement exists for the derived median line of the feature of size. 5. Where a straightness tolerance is applied to a surface element that is associated with a size dimension, and Rule #1 does not apply to the size dimension (i.e., overridden, independency, stock size, etc.), the straightness tolerance value may be smaller than the size tolerance.
A particular low head hydro system has the water ?flow dropping 30 ft. and produces 96 kW. What is the ratio of elevation decrease to kW produced for this system?
Fill in the blank(s) with the appropriate word(s).
Punishment and extinction have a common fault. What is it?
a. Both involve the use of avoidance. b. Both involve the use of fixed interval reinforcement schedules, which are the least effective schedules. c. Both fail to prescribe the desired behavior. d. Both are process theories of motivation. e. Both depend on the target's perception of equity.