Determine electrical needed for the Real Estate Office in Appendix E. Using the labor rates from Problem 7-31 and the crew rate for the electrical crew from Problem 7-32 determine the cost for the electrical.
What will be an ideal response?
The following can be extracted from the model:
The following electrical components are needed:
19 ea single-pole switches
10 ea three-way switches
15 ea phone jacks
2 ea phone jacks – floor mount
79 ea duplex outlets
2 ea duplex outlets – floor mount
3 ea GFI duplex outlets
2 ea GFI duplex outlets with weatherproof covers for use outside
83 ea 2-foot by 2-foot fluorescent light fixtures
6 ea can light fixtures
3 ea surface-mount light fixtures
1 ea panel
Allowing eight lights or outlets per circuit, 23 each 20-amp circuits will be needed, plus circuits for the heat and cooling system (allow a 40-amp circuit) and the water heater (allow a 30-amp circuit). Allow for one 30-space 225-amp panel and one 225-amp main breaker panel and one meter base.
The following approximate wiring quantities are needed. The quantities were measured in OnScreen Takeoff and will vary based upon which outlets are placed on which circuit:
322 ft 3-12 Romex
2,655 ft 2-12 Romex
756 ft phone wire
64 ft 4/0 wire and 32 ft #8 wire (connect panels)
100 ft #6 wire (heating)
30 ft #4 wire (water heater)
You might also like to view...
The least costly time to fix a drawing error is while it is in the ____________________ department.
Fill in the blank(s) with the appropriate word(s).
PROBLEM 2.13
Rod BD is made of steel and is used to brace the axially compressed member ABC. The maximum force that can be developed in member BD is 0.02P. If the stress must not exceed 18 ksi and the maximum change in length of BD must not exceed 0.001 times the length of ABC, determine the smallest-diameter rod that can be used for member BD.
Explain some of the many different roles of the farmer
What will be an ideal response?
What parasites commonly infest tarantulas?
What will be an ideal response?