Reinforced-concrete tilt-up walls are generally used as _______.
A) non-load-bearing enclosure walls whereas the entire structure consists of a structural
steel frame.
B) load-bearing enclosure walls whereas the interior structure consists of a precast-concrete
frame.
C) load-bearing enclosure walls whereas the interior structure consists of a cast-in-place
reinforced-concrete frame.
D) load-bearing enclosure walls whereas the interior structure consists of a structural steel
frame.
E) any one of the above.
D) load-bearing enclosure walls whereas the interior structure consists of a structural steel
frame.
You might also like to view...
Briefly describe the two general types of honeypots.
What will be an ideal response?
Drip edge flashings are installed at eave and rake of a steep roof. Are these flashings installed above roof underlayment or below it?
What will be an ideal response?
What test would you perform to make sure that the wheel bearing is not too tight?
What will be an ideal response?
____________________ systems interlock the power supply and wire feeder.
Fill in the blank(s) with the appropriate word(s).