Where a cylindricity tolerance is applied to a surface that is associated with a size dimension, and Rule #1 applies to the size dimension, the cylindricity tolerance value must be ____________________ the difference between the size tolerance limits.
Fill in the blank(s) with the appropriate word(s).
ANS: less than
You might also like to view...
A sphere of ice, 5 cm in diameter, is exposed to 65 km/h wind with 15 percent relative humidity. Both the ice sphere and air are at ? 1°C and 90 kPa. Predict the rate of evaporation of the ice in g/h by use of the following correlation for single spheres: Sh = [4.0 + 1.21 (ReSc)2/3]0.5. Data at ? 1°C and 90 kPa: , kinematic viscosity (air) = 1.32 × 10?7 m2/s, vapor pressure (H2O) = 0.56 kPa and density (ice) = 915 kg/m3.
What will be an ideal response?
Completely clogged air filters can lead to ____.
A. low evaporator fan amperage B. compressor damage C. evaporator ice formation D. all of the above
What is Konqueror?
What will be an ideal response?
A _____ consists of two individual U-joints connected by a centering socket yoke and a center yoke that functions like a ball and socket.
A. single Cardan Universal joint B. double Cardan Universal joint C. CV joint D. drive shaft