Explain the steps used to make a crosscut bevel
What will be an ideal response?
When cutting a bevel, the following steps are required: (1) elevate the saw about 2 inches above the
table, (2) loosen the bevel latch, (3) swing the saw assembly to the desired angle as shown on the bevel
scale, (4) tighten the bevel latch, (5) lower the saw to the table, and then (6) proceed.
You might also like to view...
A well driller bores a 532-foot geothermal exchange well in 14 hours. Find the average depth drilled in 1 hour.
Fill in the blank(s) with the appropriate word(s).
A ____________________ is a short length of wire used in electrical boxes to make connections to device terminals.
Fill in the blank(s) with the appropriate word(s).
The purpose of a seat belt pretensioner is ________
A) To force the occupant into position against the seat back B) To remove slack from the safety belt C) Both A and B D) Neither A nor B
At a gauge pressure of 28.9"Hg, the equivalent reading on a micron gauge is about __________ microns.
A. 24, 500 B. 25, 400 C. 42, 500 D. 54, 200