In what position in the crimp-on terminal must the conductor insulation be for a proper connection?
a. Outside the inspection hole
b. In the belled mouth
c. Below the inspection hole
d. Above the belled mouth
b
You might also like to view...
Three resistors having values of 150 ohms, 300 ohms, and 100 ohms are connected in parallel. What is the total resistance in ohms?
a. 50 b. 100 c. 150 d. 300
Technician A says reverse twist rings do better controlling blowby. Technician B says standard torsional twist rings do better controlling oil. Who is correct?
A. Technician A B. Technician B C. Both technicians D. Neither technician
In a typical measurement system, with a single cut-off frequency, what can you say about the attenuation in the output amplitudes for frequencies just above (but close to) the cut-off frequency?
A. there is partial attentuation B. there is no attenuation C. there is full attentuation
A three-phase wye-connected load is connected to a 480 V three-phase line. The line current is 36 A. If this load is purely resistive, what is the total amount of power being used in this circuit?
A. 51.84 kW B. 29.93 kW C. 7.48 kW D. 12.96 kW