A Sallen-Key filter with a Butterworth response must have a damping factor of
A) 1 B) 2 C) 0.586 D) 1.414
D
You might also like to view...
If the G-code is G20 G90 F6 G01 Z1.00:
A. The spindle will move at a rate of 6 inches per minute to a point where z = 1.00 in. B. The spindle will move at a rate of 6 inches per minute for a distance of 1.00 in. C. The spindle will move at a rate of 6 millimeters per minute to a point where z = 1.00 mm D. The spindle will move at a rate of 6 millimeters per minute for a distance of 1.00 mm
How is placement of the compressor line determined when drawing a PH diagram of an operating system?
A) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant entropy lines up until it crosses the condenser line. B) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant quality lines up until it crosses the condenser line. C) The compressor line starts where the condenser line crosses the suction line temperature and follows the constant entropy lines up until it crosses the evaporator line. D) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant enthalpy lines up until it crosses the condenser line.
Refer to the figure. Assume 2" Threaded. Find e-e of pipe J
Fill in the blank(s) with the appropriate word(s).
In a JFET, the U- shaped region is called the ____ and is flush with the upper surface of the substrate.
A. channel B. gate C. source D. drain