?A major disadvantage of cold-mold thermoforming is that it____.
A. ?requires a high skill level
B. ?is unsafe for workers
C. ?has a low production rate
D. ?requires additional curing time
Answer: D
You might also like to view...
The clutch_______ applies pressure to the clutch plates and friction discs.
A. drive pulley B. pressure plate C. center ramp D. judder spring
In 1833, in the first example of factory reform legislation, the British Parliament’s Factory Act outlawed textile factory labor for children under what age?
a. under age 5 b. under age 7 c. under age 9 d. under age 13
Which of the following values for IAC count would indicate a vacuum leak on a speed density system?
A) 15 B) 30 or more C) 5 or less D) 25
on the cone clutch limited slip, the rear are splined into (A) the cone clutch differential side gears or (B) the spring block. which is correct
A. a only B. b only C. both a and b D. neither A nor B