Why would 400 SPFM be better that 100 SFPM when carbide cutting tools?
A) Less heat is produced at 400 SFPM than at 100 SFPM
B) There would be better shaped chips
C) The higher speed would provide a better finish
D) The higher speed is less likely to burn the edge of a cutting tool
C
You might also like to view...
The secret Gentlemen's Agreement that President Theodore Roosevelt worked out with the Japanese in 1907-1908
A. concluded the Russo-Japanese War. B. helped him to win the Nobel Peace Prize. C. caused Japan to halt the flow of laborers to America in return for the repeal of a racist school decree by the San Francisco School Board. D. put a stop to the racist yellow journalism being practiced in the United States. E. None of these choices are correct.
The best way to remove a belt from a belt drive is to
A) Loosen the mount on the drive pulley to create slack in the belt B) Remove the drive pulley from the motor C) Roll the belt over the edge of the larger pulley D) Roll the belt over the edge of the smaller pulley
A TI 36X calculator is set in binary mode (BIN). The calculator display show 110100101. If the calculator is set to decimal (DEC) mode, what would the display show?
Fill in the blank(s) with the appropriate word(s).
Division 9 deals with __________.
Fill in the blank(s) with the appropriate word(s).