What is the modulus of a 5-bit Johnson counter?

A) 10 B) 20 C) 32 D) 5


A

Trades & Technology

You might also like to view...

Where the MMC modifier is specified in the tolerance portion of a feature control frame, what four items should come to mind?

What will be an ideal response?

Trades & Technology

The divisions on Engineer's scales are in increments of ____.

A. tenths of a millimeter B. eighths of a millimeter C. tenths of an inch D. eighths of an inch

Trades & Technology

All of the following concerning the use of jumper wires are true except:

A. The jumper should be fused B. The jumper wire can be used to by-pass a switch C. The jumper wire can be used to by-pass the load device D. It can be used to supply an alternate ground circuit

Trades & Technology

For which of the following measurements is area used?

A) Surfaces B) Lines C) Depth D) Volume

Trades & Technology