If a feature is produced at ____, the form is allowed to vary within the geometric tolerance zone.

A. LMC
B. MMC
C. RFS
D. both a and c
E. none of the above


Answer: A

Trades & Technology

You might also like to view...

Which of these contribute to thatch buildup?

A) low nitrogen fertilization B) high pH levels C) ?low pH levels D) vigorous cultivars

Trades & Technology

Where is the liquid receiver located?

A) On the low side just before the compressor B) On the low side just after the metering device C) On the high side just after the compressor D) On the high side just after the condenser

Trades & Technology

If two out of phase signals are applied to the inputs of a differential amplifier it is operating in

A) single-ended mode B) differential mode C) common mode D) common rejection mode

Trades & Technology

List four positive values of wildlife’s relationship with humans

What will be an ideal response?

Trades & Technology