The cutting plane is offset through staggered interior features of an object to show those features in section as if they were in the same plane.
A. Aligned section
B. Removed section alignment method
C. Broken out section
D. Offset section
E. Use a revolved section broken away so the section can be dimensioned.
Answer: D
You might also like to view...
Based on the front and right side views, how should A1 be located on A4?
Review drawing number 523879C0A and then answer the question.
? Identify and state the historical significance of Valeriano Weyler.
What will be an ideal response?
An FET's constant current region
A) depends on gate-source voltage as shown on drain curve B) is between pinch-off voltage and breakdown region on characteristic curve C) covers a relatively wide drain-source voltage range D) all of the above
It is only possible to go in the forward direction when a jump command is used.
Answer the following statement true (T) or false (F)