When the workpiece is electromechanically charged, it becomes easier to machine.
Answer the following statement true (T) or false (F)
True
You might also like to view...
How far below the finished surface should snow-melting and anti-icing systems be installed?
a. 1/4 to 1/2 inch (6 to 13 mm) b. 1-1/2 to 2 inches (4 to 5 cm) c. 2 to 3 inches (5 to 8 cm) d. 3 to 4 inches (8 to 10 cm)
The run winding on a compressor has a resistance of 0 ohms. This indicates that:
A) The winding has continuity and is good. B) The winding is open. C) The winding is grounded. D) The winding is shorted.
For solar hot water, there should be an area ____ adjacent to the conventional water heater in the utility room for the future solar hot water tank.
A. 3' x 2' x 6' B. 3' x 3' x 8' C. 4' x 2' x 7' D. 4' x 3' x 8'
The leading industry in the American colonies was
A. fishing. B. manufacturing. C. commerce. D. agriculture. E. slave trading.