A knock sensor is designed to detect ________ in the engine
A) Water pump noise B) Valve knock C) Rod knocking D) Spark knock
D
You might also like to view...
?When would GTA welding be a good choice for making pipe welds?
A. ?When the joint must have a high degree of integrity. B. ?If the joint has too narrow of a root gap. C. ?If the joint has too wide of a root gap. D. ?For 6G pipe joints and when pipe flanges are being installed at the ends of pipe runs.
A desiccant wheel dehumidifier removes water from the air
A) by passing the air over a refrigerated evaporator coil B) by spinning the air until water is removed by centrifugal force C) by absorbing it in a chemical desiccant D) by passing the air through an open gas flame
The form used to report work-related injuries and illnesses is _____
a. DOT Form 75 b. OSHA Form 300/300A c. IRS Form 1040A d. OSHA Form 301
Technician A says that HVLP spray guns not only cut material costs, but they are also required in some areas. Technician B says that only HVLP spray guns can have a transfer efficiency of 65 percent or greater. Who is correct?
A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B