?When would GTA welding be a good choice for making pipe welds?
A. ?When the joint must have a high degree of integrity.
B. ?If the joint has too narrow of a root gap.
C. ?If the joint has too wide of a root gap.
D. ?For 6G pipe joints and when pipe flanges are being installed at the ends of pipe runs.
Answer: A
You might also like to view...
When specifying a stud weld, the arrow of the welding symbol points to the ____.
A. surface to which the stud is to be welded B. prepared joint C. prepared stud D. joint surface
Technician A says when installing an outer tie-rod end, the slot in the tie-rod sleeve must be directly above the opening in the sleeve clamp. Technician B says excessive front wheel toe change and wear on the front tire treads may be caused by a loose tie-rod end. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
Answer the following statement(s) true (T) or false (F)
LP gases are derived from the refining processes for natural gas and crude oil.
Describe how a risk can be considered “acceptable.”
What will be an ideal response?