A) Brake bias
B) Inertia
C) Friction
D) Weight bias
If a fault is found with a synchronizer hub (too tight of a fit), what should be done?
A) Replace the synchronizer sleeve
B) Heat and then chill the hub and re -check
C) Polish the hub and reuse it
D) Replace the complete synchronizer assembly
D) Replace the complete synchronizer assembly
Trades & Technology
You might also like to view...
The ____________________ is made up of an assortment of electronic devices interconnected by electric cables.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
Technician A says that a common cause of top end clatter in a diesel engine is loose set cylinder valves. Technician B says that loose set valves are subject to lower shock loads on opening and closing because they travel less distance. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Trades & Technology
Weight transfer during braking is caused by ________.
Trades & Technology
The subsequent problems deal with the figure below. Assume all outputs are low to begin with unless indicated otherwise.
What does the following PicBasic code do?Low PORTB.2myloop:If (PORTA.1 == 1) ThenHigh PORTB.2ElseLow PORTB.2EndIfGoto myloopHigh PORTB.2
A. keeps LED L1 on only while button B3 is up (i.e., not held down) B. keeps LED L1 on while button B3 is held down, and keeps it on after the button is released C. blinks LED L1 while button B3 is up (not held down), turns on the LED when the button is pressed, and turns it off when the button is released. D. keeps LED L1 on only while button B3 is held down E. turns LED L1 off when button B3 is pressed down, and keeps it off after button B3 is released
Trades & Technology