If you are not sure which filler metal to use, a good general rule is that a lower strength or grade can be used successfully, but a little stronger or higher grade seldom works.
Answer the following statement true (T) or false (F)
False
You might also like to view...
The hole locations of the block in the accompanying figure are checked by placing the block on a surface plate and indicating the bottom of each hole using a height gage with an indicator attachment. Determine the height gage settings from the bottom of the part to the bottom of hole 2.
What will be an ideal response?
Compared with the feed rate for drilling the same material, the feed rate for reaming is ________ that for drilling
A) 2 times B) Equal C) 4 times D) One-half
A BCD-to-7-segment decoder converts a BCD value into a pattern that can be displayed as hexadecimal digits
Indicate whether the statement is true or false
A faulty A/C system has a high low-side pressure and a high high-side pressure. Technician A says that the system is probably starved. Technician B says that the system has a bad thermostatic switch. Who is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B