When a cylinder head bolt torque specification requires that the fastener is first torqued, then turned through a further set number of degrees, the method is known as:
A. template torque
B. twist torque
C. constant clamping force
D. bolt tensioning
Answer: A
You might also like to view...
Express 7/18 as a decimal fraction. Round to the nearest hundredth.
Reduce all fractions to their simplest forms. Convert all improper fractions to mixed numbers. Provide answers in the following format: Fraction: 3/4 Mixed number: 1 5/8
The caliper dust boot may need to be pried out with a(n) ________
A) C-clamp B) Screwdriver C) Air chisel D) Special tool
When clamping parts with finished surfaces in a bench vise:
A) Soft jaws should be used B) A cheater should be used on the handle to gain leverage C) They should be gripped very lightly so that rough jaws will not mar finished surfaces D) They should be gripped very lightly so the smooth surface will not cause it to slip out of the jaws
A mixture of oil and oxygen could cause _____
a. corrosion b. an explosion c. low torch heat d. excessive torch heat