Technician A says that the top mounting nut for a rear shock absorber is often located inside the vehicle. Technician B says that shocks, struts, and springs should always be replaced in axle sets. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
C
You might also like to view...
Which are the two steps that must follow after the ceramic floor tiles have been laid?
What will be an ideal response?
A thermal system overload may occur if a specific electrical or mechanical component is not cooled properly, resulting in ____.
A. underload B. failure C. stagnation pressure D. ?overheating
The following results were obtained by a mechanical analysis. Classify the soil using the AASHTO classification system and give the group index. Sieve Analysis, % Finer than No. 10: 84%, than No. 40: 58%, than No. 200: 8%; soil is not plastic.
What will be an ideal response?
Discuss what the auto manufacturers do to increase the strength factor of a die-stamped panel and what happens to accomplish this.
What will be an ideal response?