While discussing measuring tools, Technician A says that when measuring clearance with a feeler gauge, there should be a slight drag when the feeler strip is moved through the area of clearance. Technician B says that if a feeler gauge that is 0.001" thicker will not fit into the gap, the correct measurement has been made. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: C
You might also like to view...
What are the coordinates of point F in the accompanying figure?
A. (1,-7) B. (-1,7) C. (3,2) D. (-1,-7)
The essential piece of information A/D personnel need before beginning lattice-boom assembly is _____.
a. the model and length of the boom required for the job b. the maximum load capaity of the crane c. whether the crane can operate 360 degrees d. whether the crane’s counterweight is extendable
If low-voltage and high-voltage cables must be placed in parallel runs, they should be separated by at least 6" (150 mm) in order to protect the low-voltage conductors from _____.
a. noise b. corrosion c. heat d. vibration
While discussing drill bits, Technician A says that a drill bit that is sharpened "off center" will drill a hole that is too small. Technician B says that it will drill a hole that is too large. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B