The ring gear teeth of a flywheel are badly worn in various spots. Technician A says this could cause poor drive gear engagement. Technician B says this could cause a lower-than-normal starter current draw. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technician A and B
D. Neither Technician A nor B
Answer: A
You might also like to view...
Which of these is NOT a normal diagnostic step when troubleshooting a transfer case problem?
A) Check sensor data with a scan tool B) Remove and inspect the front driveshaft C) Check the fluid level D) Measure the tire circumference
Among the 2-by members, the grades of "Construction," "Standard," and "Utility" are limited to a certain cross-sectional size. Which size is that size?
What will be an ideal response?
Technician A says that in a truck using virtual circuit protection devices, the circuit is tripped open when logic analysis of the circuit conditions determines that it is overloaded. Technician B says that when a virtual fuse trips open, it must be replaced by another using the identical OEM part number. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
There are two conductors, a red and a blue installed in metallic conduit. You are using a MEGGER to test for shorts. How should the two leads of the MEGGER should be connected?
A. one to the blue lead and one to the conduit B. one to the red lead and one to the conduit C. one to the blue lead and one to the red lead D. both to the conduit