When using the division-by-2 method of converting from decimal to binary, the first remainder represents the:
A) LSB of the equivalent binary value.
B) LSB of the equivalent binary value, providing the final remainder is used to replace the original LSB, which is then moved to the MSB position.
C) MSB of the equivalent binary value, providing the following sequence of remainders are written in descending order until the final remainder is achieved. The final remainder is used to replace the original MSB which is discarded.
D) MSB of the equivalent binary value.
A
You might also like to view...
The last step after replacing a defective CV boot is to ________.
A) Separate the CV joint before installation B) Mark the location of the boot on the drive axle shaft C) "Burp" the boot D) Lubricate the CV joint with chassis grease
After a TP sensor has been tested using the MIN/MAX function on a DMM, a reading of zero volts is displayed. What does this reading indicate?
A) The TP sensor signal is shorted to 5-volt reference. B) The TP sensor is open at one point during the test. C) The TP sensor is shorted. D) Both B and C are possible.
What type of information is shown in the job specifications for a project superintendent?
What will be an ideal response?
To avoid an accident you moved to the shoulder. Forced to return to the road, you should:
a. Ride on shoulder to the next exit and then re-enter the road. b. Using mirrors and turn signals, return when the road is clear. c. Using mirrors and turn signals, turn sharply to get back to the road.