Describe the practice for representing a sheet metal part using a flat pattern with manufacturing information extracted to a table.
What will be an ideal response?
Tables are commonly used for a variety of drafting applications, including tabular dimensioning. A table is an arrangement of rows and columns that organize data to make it easier to read. Some CADD applications allow you to extract existing model or drawing data to form a table. For example, you can create a hole table from hole features or a bend table from sheet metal bends. You can also create general tables for other applications.
You might also like to view...
Each time a cell divides into two daughter cells, its full ____________________ is duplicated.
Fill in the blank(s) with the appropriate word(s).
La cantidad de puntas de flecha colocada en líneas de circuito:
a. indica la sala en la que se instala el circuito. b. indica que el circuito será controlado por un interruptor de pared. c. muestra la cantidad de circuitos. d. muestra la dirección del flujo de corriente.
75%
A) 0.75 B) 0.075 C) 7500 D) None of these
Which of the following should not be done when changing the engine fuel filters?
A. Tighten the secondary fuel filter until the rubber gasket makes contact with the filter base; then tighten and additional half turn. B. Install the primary fuel filter and spin it on, leaving the filter loose. C. Fill both the primary and secondary filter with fuel before installation. D. Operate the manual hand pump located on the injection pump until fuel bubbles surround the top of the primary filter.