Taps are used to cut external threads; dies are used to cut internal threads.
Answer the following statement true (T) or false (F)
False
You might also like to view...
An incorrect SAI angle on a MacPherson strut front suspension may be caused by all of these defects EXCEPT:
A. A bent lower control arm B. A shifted engine cradle C. An upper strut tower out of position D. A bent stabilizer bar
A stick-built glass-aluminum curtain wall system consists of horizontal and vertical framing members, called rails andmullions respectively. In anchoring them to the building's structural frame, which of these (rails or mullions) are installed first? Are the members that are installed second also anchored directly to the building's structural frame?
What will be an ideal response?
Which of the following would be the most likely handling result when a spring pack centerbolt breaks?
A. Hard steering B. Bouncing front end C. U-bolt failure D. Leaf breakage
Why should the stator insulation resistance be checked during multiple PM cycles throughout the service life of the generator?
What will be an ideal response?