What is a low water cutout?

A) It is an operating control that shuts off the boiler at the end of every operating cycle when it senses that the boiler has used up its supply of water.
B) It is a hand valve installed near the bottom of the boiler, which is used for filling and servicing the boiler.
C) It is an operating control that energizes the water fill solenoid at the end of an automatic blow-down cycle.
D) It is a safety device that shuts off the boiler if the water level is low.


D

Trades & Technology

You might also like to view...

How far from the left side of the part is the center of the center hole?

Review drawing number 522973A0A and then answer the question.

Trades & Technology

Is angle F a right angle or a straight angle?

What will be an ideal response?

Trades & Technology

In a schedule, _____ is the amount of time before you start affecting the project.

a. shared float b. total float c. free float d. negative float

Trades & Technology

Front wheel bearings on rear-wheel-drive vehicles do not wear out very often. However, bearing misalignment can be caused by a bent spindle; this increases the load on the bearing.

Answer the following statement true (T) or false (F)

Trades & Technology